Electronics Line 3208GLD Bedienungsanleitung PDF herunterladen (Seite 20)

3.11: Tests

Walk Test

The walk test allows detection devices to be tested without generating an alarm.

To perform a walk test:

1. Press SELECT 4, 2, 1 or select Walk Test from the Test menu.

2. Test the control panel’s detection devices; an opened zone causes the keypad to beep.

3. To end the walk test, press AWAY.

Walk test mode is automatically terminated after 4 minutes and 15 seconds.

Note: During a walk test, an open zone will not create an alarm. However, this does not apply to

zones programmed as tamper zones and 24hr zones (Emergency/Holdup, Fire and Verified Fire)

opening these zones will create an alarm.

Bell Test

To perform a bell test:

• Press SELECT 4, 2, 2 or select Bell Test from the Test menu; a 1 second ring is heard and the test is

terminated automatically.

Telephone Communicator Test

To perform a telephone communicator test:

• Press SELECT 4, 2, 3 or select Telephone Test from the Test menu; a test message is sent to all

central stations that are programmed to receive communications from the control panel. The control

panel returns to normal operation after the telephone communication test is initiated. The report code

for this message is at address 251 or 285.

Note: The control panel seizes the telephone line to run this test.

System Test

To perform a system test:

• Press “SELECT” 4, 2, 5 or select System Test from the Test menu; the system tests the control panel’s

electronic circuitry. Should the LCD display the message “System Failure”, contact our technical

support department.

Battery Test

To perform a battery test:

• Press “SELECT” 4, 2, 6 or select Batt. from the Test menu; the battery is tested under loading

conditions, the control panel returns to normal operation and the battery status display is updated. For

the test to be successful the voltage must not be lower than 10.8V under loading conditions. This test is

automatically executed by the system every 30 seconds.

3.12: Additional Operations

Set Time & Date

To set the time and date:

1. On the LCD keypad, press SELECT 4, 1; the panel prompts you to enter a user code.

2. Enter an authorized user code; the panel prompts you to set the date.

3. Enter the date (DDMMYY).

4. Enter the time in 24 hour format (HHMM).

5. Press AWAY; the panel returns to normal operation.

1. On the LED keypad, press SELECT 4, 1; the Program LED lights up.

2. Enter an authorized user code.

3. Enter the date (DDMMYY).

4. Enter the time in 24 hour format (HHMM).

5. Press AWAY; the Program LED turns off.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 50 51

Kommentare zu diesen Handbüchern

Keine Kommentare

Electronics Line 3208GLD Bedienungsanleitung Seite 20

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sicherheitszugriffskontrollsysteme Electronics Line 3208GLD