Electronics Line iconnect Bedienungsanleitung PDF herunterladen (Seite 13)

3.3: Command Codes

Commands are executed by pressing the ‘Q‘ button followed by the corresponding

command number and, in some cases, a valid user code. The following is a summary

of the command codes used in system operation.

Quick Arm

Q5 + (User Code 1)

Program User Codes

Q1 + (User Code)

Bypass Mode

Zone Chime

Emergency/Trouble

Event Log

Q7 + (Installer Code)

Programming Mode

Zone Alarm

Event Log

Q8 + (User Code)

Forced Arming

Bell/LED Test

Q9 + (User Code)

Stay Arming

3.4: Arming/Disarming

The following section explains the various arming and disarming methods.

Arming

When all zones are secured the system can be armed normally. Arming the system

transmits a message to the central station identifying which user performed the

operation.

To arm the system:

1. Check that all zones are closed; the Ready LED lights up to indicate that the

system is ready to be armed.

2. Enter a valid user code; the keypad beeps until the end of the exit delay.

Forced Arming

Forced arming enables the user to arm the system with open zones. Electronics Line

recommends waiting until all of the zones are secured and the system can be armed

normally. Note: If zones are still not secured after the exit delay has ended, an

alarm will be generated.

To force arm the system:

1. Press Q, 8.

2. Enter a valid user code; the keypad beeps until the end of the exit delay.

Quick Arming

This feature allows the Penta to be armed without a valid user code. Quick arming the

system transmits an “Armed by User 1” message to the central station.

To “Quick” arm the system:

1. Check that all zones are closed; the Ready LED lights up to indicate that the

system is ready to be armed.

2. Press Q, 0; the keypad beeps until the end of the exit delay.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 32 33

Kommentare zu diesen Handbüchern

Keine Kommentare

Electronics Line iconnect Bedienungsanleitung Seite 13

Kommentare zu diesen Handbüchern