Electronics Line iconnect Bedienungsanleitung PDF herunterladen (Seite 11)

4. Connect the keypad to the control panel according to the following diagram.

5. Reassemble the front and back cover of the keypad.

2.6: Turning on the System

Once all of the systems components are properly connected to their destination

terminals, the Penta is ready to be turned on. To avoid the risk of electrical shock or

damage to the control panel, make sure that both the AC supply and the battery are

connected properly before plugging in the system. If you experience any difficulties in

applying power to the unit, please contact Electronics Line’s Technical Support

Department. The Penta control panel is supplied with a default program that includes

typical programming data which means that minimum programming is required for

typical installations.

To turn on the system:

1. Install the JPD jumper located at the top of the board.

2. Reapply power and wait for 10 seconds; the keypad beeps to indicate the end of the

10 second period.

3. Disconnect both the AC and battery power supply.

4. Remove the JPD jumper.

5. Reapply power; the default program is restored.

The default settings can be reset at any time by disconnnecting the power supply and

repeating the above procedure.

CONTROL PANEL

KEYPAD

4 5

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 32 33

Keine Kommentare

Electronics Line iconnect Bedienungsanleitung Seite 11